Skip to content

PHM Technology

Contact Details

PHM Technology
http://www.phmtechnology.com
Contact: Chris Stecki
Address: 9/120 Queens Parade, Clifton Hill Victoria 3068
Phone: +61 3 9482 2007

Capability

MADe PHM was developed to optimize the development of CBM / PHM capability.

Each failure mode in a MADe system model is propagated to establish its functional dependencies and a syndrome of system response is generated autonomously.

These ‘failure syndromes’ enable a system level view of the impacts of the failure and increase the confidence level for diagnostic solutions and are used to perform the following analysis:

  • Automated Sensor Set Generation,
  • Fault Detection Coverage Analysis,
  • Fault Detection and Isolation (FDI) Analysis,
  • Fault Isolation Performance Assessment,
  • Fault Detection Accuracy Analysis,
  • Sensor Optimization

Tools exist to that allow the user to focus the design of the sensor sets based on parameters such as the criticality of failure modes, the cost of the diagnostic solution, the location of the sensors and their expected reliability and performance. and generates the following outputs:

  • Sensor set design / validation
  • Fault Detection & Isolation analysis
  • Ambiguity Analysis
  • Automated diagnostic rule generation
  • Probability of Detection (POD) for sensors

Discriminators

  • Automated sensor set design
  • Automated generation of diagnostic rules
  • Diagnostic designs can be generated early enough in the design process to inform the R&M and safety analysis

Key Customers

  • BAE Systems
  • General Atomic
  • NASA
  • Sikorsky

Key Partners

  • ATOS Australia
  • BMT D&T Group
  • LSC Group (Babcock)
  • Integrated Vehicle Health Management Centre – Cranfield University (UK)
  • Center for Advanced Lifecycle Engineering – University of Maryland (US)

Quality Approvals/Awards

  • 2009 IBM R&D Award (Australian Information Industy Association)
  • 2010 British Airways UKTI Market Entry – Entrepreneur category